Burkert Flowave 8098, Operating Instructions Manual, Page: 204 / 354

204
SAW sensor – Parameter
Type 8098 FLOWave L
15.10.4 Deactivating the monitoring of each volume totalizer
By default, the volume totalizers are not monitored.
But if the monitoring of a volume totalizer is active, do the following to deactivate it:
→
Go to the
CONFIGURATION
view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values Totalizer 1 or Totalizer 2
→
Limits
→
Active
→
No .
→
Save.
The monitoring of the volume totalizer is inactive.
15.10.5 Changing the error limits, the warning limits and the hysteresis
of each volume totalizer
To change the error limits, the warning limits and the hysteresis of each volume totalizer, do the following:
→
Go to the
CONFIGURATION
view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values Totalizer 1 or Totalizer 2
→
Limits
→
Settings The Current settings are displayed
→
Set the high error limit
→
Set the low error limit
→
Set the high warning limit
→
Set the low warning limit
→
Set the hysteresis value The New settings are displayed.
→
Save.
The limit values and the hysteresis value are changed.
English