Burkert Flowave 8098, Operating Instructions Manual

Page: 202 / 354

202
SAW sensor – Parameter
Type 8098 FLOWave L
15.10 Setting the parameters of the volume totalizers
15.10.1 Giving a user defined name to each volume totalizer
The name is used to identify the process value in the user defined views and in all the menus where the
process value is displayed (for example in the Outputs menu).
By default, the names associated to the volume totalizers are
Totalizer 1
and
Totalizer 2
.
To add a user defined name to the default name of a volume totalizer, do the following:
→
Go to the
CONFIGURATION
view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values
→
Totalizer 1 or Totalizer 2
→
Value name .
→
Enter the name by selecting and confirming each character. The name can have up to 19
characters.
→
OK
→
Save the name.
The name is changed.
15.10.2 Choosing the counting direction of each volume totalizer
By default, the counting direction of both volume totalizers is Positive only .
The possible counting directions are:
•
Positive only : the volume totalizer counts the volume of liquid that flows in the direction defined as
positive, i.e. in the same direction as the arrow located on the front of the device.
•
Negative only
: the volume totalizer counts the volume of liquid that flows in the direction defined as
negative, i.e. in the direction opposite to the direction of the arrow located on the front of the device.
• Both : the volume totalizer counts the volume of liquid that flows in the direction defined as positive but
deducts the volume of liquid that flows in the direction defined as negative.
To change the counting direction of each volume totalizer, do the following:
→
Go to the
CONFIGURATION
view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values Totalizer 1 or Totalizer 2
English