Burkert Flowave 8098, Operating Instructions Manual

Page: 200 / 354

200
SAW sensor – Parameter
Type 8098 FLOWave L
→
Stand. meas. values
→
Density
→
Limits
→
Reset to default
→
Confirm.
The limit values and the hysteresis value are reset.
→
Go back to the parent menu.
15.9.9 Setting the measurement mode of liquid density
Density mode can be selected through the following values:
•
Measured (value measured via SAW signals, and liquid temperature)
• Water (value calculated based on liquid temperature measured by FLOWave)
• Constant (value set to a constant value)
• Linear ( r = a+bT; coefficients a and b to be set by installer, T in °C)
• Quadratic (
r
= a+bT+cT
2
; coefficients a, b and c to be set by installer, T in °C)
When option Density is ordered, default density mode will be Measured .
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the
Parameter
view.
→
Stand. meas. values
→
Density
→
Mode The Current settings are displayed.
→
Choose the density mode between Measured , Water , Constant , Linear , Quadratic
→
If coefficients have to be set (in Constant , Linear , Quadratic mode), then set the values
English