Burkert Flowave 8098, Operating Instructions Manual

Page: 160 / 354

160
SAW sensor – Parameter
Type 8098 FLOWave L
15.4.10 Changing the cut-off value of the volume flow rate
The default value of the cut-off volume flow rate is equal to 0.4 % of the full scale value. The full scale
depends on the DN of the measurement tube.
To change the cut-off value of the volume flow rate, do the following:
→
Go to the
CONFIGURATION
view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values
→
Volume flow
→
Cut-off
→
Value
→
Set the cut-off value.
→
Save.
The cut-off value of the volume flow rate is changed.
15.4.11 Disabling the cut-off function of the volume flow rate
If the cut-off function is enabled, do the following to disable it:
→
Go to the
CONFIGURATION
view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values
→
Volume flow
→
Cut-off
→
Status
→
Disabled
→
Save.
The cut-off function is disabled.
English