Burkert Flowave 8098, Operating Instructions Manual, Page: 125 / 354

125
General settings – Parameter
Type 8098 FLOWave L
12.17 Deactivating the adjustment protection through
passwords
By default, the device adjustment is not protected by passwords.
The default user level is the
Installer level.
If the adjustment protection through passwords has been activated, do the following to deactivate it:
→
Go to the CONFIGURATION view
→
General settings
→
Confirm to access the Parameter view.
→
Passwords
→
Password protection
→
Choose Off
→
Save
The protection through passwords is disabled.
12.18 Changing the units of the physical quantities
The physical quantities, used by the device, are displayed on the device with the following default units (in
the metric unit system):
• current: mA (milliamperes)
• density: g/cm
3
(grams per cubic centimetre)
• flow rate: l/min (liters per minute)
• frequency: Hz (Hertz)
• length: mm (millimeters)
• mass: g (grams)
• mass flow rate: kg/h (kilograms per hour)
• velocity: m/s (meters per second)
• temperature: °C (degrees Celsius)
• temperature difference: °C (degrees Celsius)
• time: s (seconds)
• voltage: V (Volts)
• volume: l (liters)
To change the units of a physical quantity, do the following:
→
Go to the
CONFIGURATION
view
English