Burkert 8756, Operating Instructions Manual

Page: 52 / 88

Type 8756
Setting and operation
english 52
The product status indicator is orange.
A check-function event is generated.
Go to Actuator > Actuating variable
Do the following sequence: set 100% > wait for 5 seconds >
set 0% > wait for 5 seconds.
Repeat the previous sequence 2 times.
If the product still detects bubbles in the pipe, then contact
Bürkert.
Go to
Controller > Set-point value source > Choose Auto-
matic
The product operates normally.
8.2.6 Fill the pipe without damaging the
pump (MFC with pump)
To make sure that the pump is not damaged when filling the pipe,
do the following procedure:
Connect the product to the Bürkert Communicator software.
Refer to chapter:
Connect the product to the Bürkert Com-
municator software [
}
53]
In the Bürkert Communicator software, select the product.
Make sure that the fluid can flow.
Make sure that the suction pressure is lower than 200 mbar
during the full procedure.
Go to
Controller > Set-point value source > Choose Open-
loop control mode
The product status indicator is orange.
A check-function event is generated.
Go to Actuator > Actuating variable
Set 15%.
Wait for 60 seconds. If the product still detects that the pipe is
empty, then contact Bürkert.
Go to
Controller > Set-point value source > Choose Auto-
matic
The product operates normally.
8.2.7 Configure the actuator (MFC for
modular actuator)
Connect the product to the Bürkert Communicator software.
Refer to chapter:
Connect the product to the Bürkert Com-
municator software [
}
53]
In the Bürkert Communicator software, select the product.
Go to
Actuator > Parameter > Choose Start-Up Wizard
The product status indicator is orange.
A check-function event is generated.
Follow the instructions of the displayed wizard.
The connected actuator is configured.
The product operates normally.