
61
Troubleshooting
Type 8745 Ethernet, 8745 Analogue
12.1.10 Product status indicator is yellow
(MFM Ethernet)
Identify the cause:
1.
One of the following values is out of specification. The sensor
or the product can be damaged.
•
the fluid temperature
•
the product temperature
•
the supply voltage
→
Operate the product within the specifications. If the product
status indicator is still yellow, then send the product back to
Bürkert.
2.
The Ethernet protocol is being changed.
→
Wait until the change of protocol is completed. This can take
up to 1 minute.
12.1.11
Product status indicator is yellow
(MFC Analogue)
Identify the cause:
1.
One of the following values is out of specification. The sensor
or the product can be damaged.
•
the fluid temperature
•
the product temperature
•
the supply voltage
→
Operate the product within the specifications. If the product
status indicator is still yellow, then send the product back to
Bürkert.
2.
The set-point position for the control valve has (almost)
reached 100%. The set-point value cannot be reached.
→
Increase the inlet pressure or decrease the back pressure.
→
If the pressure drop in the pipe is too high, reduce the
pressure drop.
→
If the filters that are installed in the pipe are dirty, clean the
filters.
12.1.12
Product status indicator is yellow
(MFC Ethernet)
Identify the cause:
1.
One of the following values is out of specification. The sensor
or the product can be damaged.
•
the fluid temperature
•
the product temperature
•
the supply voltage
→
Operate the product within the specifications. If the product
status indicator is still yellow, then send the product back to
Bürkert.
2.
The set-point position for the control valve has (almost)
reached 100%. The set-point value cannot be reached.
→
Increase the inlet pressure or decrease the back pressure.
→
If the pressure drop in the pipe is too high, reduce the
pressure drop.
→
If the filters that are installed in the pipe are dirty, clean the
filters.
English
Summary of Contents for 8745 MFC Ethernet
Page 69: ......
Page 70: ...www burkert com...