Burk 8681, Additional Instructions

Page: 53 / 60

53
büS/CANopen-Design
6.19.3 Access to parameters via Bürkert Communicator
The Bürkert Communicator (Type 8920) makes it easy to read and change parameters. For a detailed description
of the Bürkert Communicator - see the relevant manual (see chapter “5.6.1” on page 24).
→
Connect the PC (with Bürkert Communicator Type 8920) to the büS/CANopen data line using the “büS stick”;
start Bürkert Communicator Type 8920
→
Click on the icon to add an interface (e.g. “büS COM8”)
→
Select the desired device in the navigation bar (left), open the
“Parameter” tab (
for special values also
“Diagnostics” or “Maintenance”)
,
search for the desired value/parameter and read it out or change:
→
Current parameter values can be read out directly at the right margin;
Parameters with a pen symbol can be overwritten with the appropriate authorisation or
step sequences can be started.
→
A restart is required after a factory reset and in order to activate changes of bus/communication settings.
6.19.4 Access to further parameters (cyclic and acyclic)
In addition to the predefined relevant parameters, further values can be read out and partially overwritten. Access
is via “Bürkert Communicator” or e.g. via Logix Designer.
The required fieldbus addresses (as well as indices / sub-indices) are shown in a Parameter list that corresponds
to the respective gateway configuration. This parameter list and other files can be found on the Bürkert website -
enter the respective ID number of the preconfigured gateway as search term and download the required files from
the ZIP container under “Downloads” / “Software”.
An
Object list for CANopen
and other required files for the Type 8681 büS/CANopen can be found on the Bürkert
website – enter the type “8681” or the ID number of the device as search term and download the corresponding
files after opening the ZIP container with the “Initiation Files”, found under “Downloads” / “Software”.
english
Type 8681 büS/CANopen