7
ELECTRICAL REQUIREMENTS
CAUTION: The dispenser must be disconnected from the power source until specified in Electrical Hook-Up.
The 120V rated dispensers have an attached cord set and require a 2-wire, grounded, individual branch circuit rated
120 volts ac, 15 amp, single phase, 60Hz. The receptacle must be within 6 feet of the machine. The mating connector is
NEMA 5-15R.
Refer to the data plate for exact electrical requirements.
ELECTRICAL HOOK-UP
CAUTION: Improper electrical installation will damage electronic components.
1. An electrician must provide electrical service as specified.
2. Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.
3. Confirm that the refrigeration switch near the main control board is in the OFF position.
4. Connect the dispenser to the power source.
5. If plumbing is to be hooked up later, be sure the dispenser is disconnected from the power source. If plumbing has
been hooked up, the dispenser is ready for Initial Fill.
PRODUCT CONCENTRATE REQUIREMENTS
The dispenser works with a range of concentrates. Some dispensers will dispense a range of 4:1 to 12:1 and
some dispensers will dispense a range of 10:1 to 32:1. Comfirm you have the correct dispenser for the concen-
trate you plan to use.
NOTE - Some concentrates may have different ratio capacities in the dispenser. Ratio capability should be con-
firmed on concentrates before installation.
Only a few product concentrate suppliers manufacture BIBs that fit directly into our dispenser. If you are
working with BIB concentrates that have a Scholle fitting or are packaged in jugs, we recommend you pour the
concentrate into our refillable containers (P/N 39302.0000).
54261.0001 090817
