Manual-HotAir-3000-en
Page 6 / 15
Scope of delivery
•
Reflow-Ofen HotAir3000
•
Foil tube D100 x 1,5 x 2 m for Exhaust
•
Hose clamp
•
This manual
•
RS232-cable
Installation
Takeover from transport companies
After receiving and unpacking the machine, check for possible transport damage. In case of trans-
port damage, please inform your insurance company, the carrier and the manufacturer / supplier.
Site
The oven must be level and around the machine there must be sufficient space for operation and
maintenance (about 1 m on all sides). When setting up the machine, observe all safety prevention
regulations and other local regulations.
The oven should be set up on a well accessible table. The surface must be level and heat resistant
and be able to carry at least a load of 30 kg.
Install the device near exhaust vent. For the connection between the stove and the vent, use the
supplied aluminum foil pipe D100.
Make sure the power supply is correctly protected (16A) and residual current protection.
The outlet height of the exhaust air should be about 1m above the machine to use the chimney ef-
fect.
Do not place any other objects on the device, especially no flammable liquids, such as: As water,
hot water, alcohol, methanol, gasoline.
The machine can be cleaned in the cooled state. Wipe the inside of the machine with a dishcloth.
You can use some rinse water or anhydrous alcohol. Do not switch on the machine until it is com-
pletely dry.
At the beginning of operation, odors may occur during operation. This is a normal phenomenon.
After a while, that kind of smell disappears.
When not in use, turn off the main switch and unplug the power cord
If you are not going to use the device for a long time, you should take it out, pack it and put it back in
the original container in order to avoid moisture damage.
If you want to solder small PCB or FPC board pieces, use a high temperature mica board. Leave at
least 30 mm space between the boards on four sides to ensure uniform heating.
The manufacturer's specifications in the menu are only clues. Use tests to determine the optimal
parameters for your application.
Temperature-sensitive precision devices such as LED, s laser head, micro connectors, soft pack-
ages, ICs u. Ä. Can be soldered by gently lowering the temperature while lengthening the times.
For components that can withstand high temperatures, you can increase the soldering temperature
accordingly to shorten the reflow soldering time.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]
