Manual-HotAir-3000-en
Page 10 / 15
Soldering Mode (WELD)
Preliminary note: the temperature and time settings in
the delivery condition of the stove are only indicative. The
parameters suitable for your application must be determ-
ined by test soldering. Please also refer to the informa-
tion provided by the solder paste manufacturer.
After pressing
ON-OFF
,
WELD
is highlighted. Press
RUN
to display the dialogue as shown in the picture on
the left.
RUN
starts the cycle, the indicator light in the upper left
corner of the display turns red and the oven starts to heat
up. The soldering cycle will be explained later. Here we
first explain the setting options.
If you press
SET
instead of
RUN
, then
READY
(pre-heat-
phase) will be highlighted. Use the arrow keys to change the text to
HEAT
,
WELD
,
HOLD
or
COOL
.
Stay on
READY
and press
SET
. The marking jumps to
TEMP
(temperature) and you can adjust the
temperature between
70
and
130°C
with the arrow keys. Another press on
SET
and you can change
the time between
00:00
and
99:99
(minutes: seconds).
Button
SET
takes you back to
READY
and here you can use the the arrow keys to go e.g. to
HEAT
to set the parameters for the heating phase. Press
SET
to go to the temperature settings and use
the arrow keys to set values between
120
and
300°C
. Another
SET
takes you to the time setting for
the heating phase.
Back to
HEAT
, press arrow down to get to the actual soldering phase.
WELD
is marked and with
SET
you can change the temperature again between
120
and 3
00 ° C
and set the time with another
SET
.
For
HOLD
, the holding time, the same applies, but the temperatures can only be adjusted between
70
and
230 ° C
here.
When you have finally arrived at
COOL
, the cooling phase, you can only set the temperature
between
70
and
200 ° C
here. A time is not set in section
COOL
, but a signal terminates the entire
soldering cycle when the set temperature is reached.
To exit the
WELD
dialogue, press
ON-OFF
.
Permanent heating mode
In the main menu, you can use the arrow keys to switch
between
USE
,
WELD
and
CONST
. Highlight
CONST
and
press
RUN
. The dialogue on the left side appears.
With
RUN
you switch on the heating, the control light
turns red and the oven heats up to the set temperature (=
SET TEMP
). The current temperature is displayed to the
left. At the same time the display changes RUN upwards
and
STOP
downwards, so that you can end the heating
process at any time by pressing the green
RUN
button. In
this case,
RUN
returns to the bottom of the display and
STOP
to the top and you can restart heating by pressing
the
RUN
key.
When the set temperature is reached, the indicator changes to green and the oven keeps the tem-
perature.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]
