Bulls 21-17-1093, Translation Of The Original Operating Instructions

Page: 35 / 139

MY21B01 - 22_1.0_10.09.2020
35
Overview
→
<Registration>
→
<FAQs>
Information on FAQs (frequently asked questions)
→
<Introduction to Kiox>
→
<Certificates>
Certifications
→
<Licence info> ◦
Information on licences
→
<Contact>
Contact details
You will find a detailed description of the
individual parameters in the online operating
instructions at
www.Bosch-eBike.com/en/Kiox-manual .
3.5.3.6 Additional journey information for
eShift Shimano DI2 and Rohloff
Only applies to pedelecs with this equipment
The gear or shift mode (Manual M/Automatic A) is
always displayed on the start screen. If you are
currently viewing another screen, the gear is
displayed briefly when the gear is changed. Since
the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is also possible to switch gears under load or on
hills. If the pedelec is brought to a halt from a
speed greater than 10 km/h, the system can
automatically switch back to a pre-set start gear.
3.5.3.7 Additional eShift system setting
Only applies to pedelecs with this equipment
The following additional functions are available on
the function display:
Applies only to pedelecs with eShift with Shimano
DI2 derailleur gears. The following additional
functions are available on the function display:
Applies only to Pedelecs with eShift with NuVinci
H|Sync/ enviolo with Optimized H|Sync
The following additional functions are available on
the function display:
3.5.3.8 System message
The drive system monitors itself continuously and
if an error is detected, it is indicated by a system
message. The system may switch off
automatically depending on the type of error. You
will find assistance for system messages in
Section
8.5 Initial help . There is a table of system
messages in the Appendix.
Indicator Change
SET START GEAR You can change the gear in this
menu option.
Table 31: Additional journey information
Indicator Change
ADJUST GEAR This is where you can make a fine
adjustment to the Shimano Di2.
You'll find the specified setting
range in the gear manufacturer's
operating instructions. Make the
fine adjustment as soon as you
hear any unusual noises from the
gear shift.
Table 32: Additional journey information
Indicator Change
CALIBRATION This is where you can perform
a calibration on the stepless
gear. Follow the instructions on
the display.
Table 33: Changing the system settings