Bullhorn RM2000 Series, Installation And Configuration Manual

Page: 40 / 82

RM2000 Series Installation and Configuration Guide
32 RM2000 Series Configuration
Load a Template
If a template is available for the unit type you plan to configure, load the template
using the following steps:
1 Click Tools > Advanced > Template > Load from Template .
2 When the Open Template window displays, locate the folder that contains
the template. Select the template and then click
Open .
3 After UCT applies the template, press F2 to read settings or click Tools >
Read Unit Settings .
4 Click File > Save Current Setup in Event Log to save settings.
Choose a Folder for Templates and Log Files
Templates and log files store in My Documents by default. If you want to store
these files in a different folder on your computer, complete the following steps:
1 Click Tools > Options to display the Options window.
2 Click Folder for Log files to display the Browse for folder window.
3 Select an existing folder or click Make New Folder to create a new folder.
4 Click Ok and then click Done to close the window.
Verify International Gateway Setting
I
MPORTANT
:
By default, International Gateway is set up for installations in the
United States. The setting determines which Gateway Control Center (GCC) the
unit uses when transmitting data to your website account. If you are uncertain
which setting to use, contact Technical Support for assistance.
To change the default setting for International Gateway:
1 Click Change in Communication Settings to display the International
Gateway window.
2 Select an option in the drop-down list and then click Accept .