READ ALL INSTRUCTIONS AND WARNINGS
BEFORE WEARING THIS HELMET
Carefully read and understand these instructions. Use this
helmet exclusively for the activities for which it is certified
(see labeling) and in strict accordance with ANSI/ISEA Z89.1.
Please refer to the shell label for specific standard “Type” and
“Class.”
WARNING
Hard hats/helmets are designed to provide limited protection
to the head by reducing the force of falling objects striking
the top of the hat shell. While limited protection is provided
in other parts of the shell, this helmet was not designed to
provide front, side, or rear impact protection. Avoid contact
with electrical wires. Never alter or modify the shell or
suspension system. Always use Bullard replacement parts.
Improper use of this helmet can cause serious or fatal injury.
If the instructions are not followed correctly the level of
protection offered by the helmet can be significantly reduced.
Inspect your helmet regularly. Check for cracks and
any sign of damage before each use. Replace helmet
immediately if you notice any signs of wear, damage, abuse,
or environmental degradation. If the helmet has sustained a
forcible blow/impact, dispose of immediately, even if damage
is not visible. Failure to follow these warnings could result in
death or serious injury.
Intended use of this helmet involves activities that are
extremely dangerous. Failure to follow these instructions
and any of these warnings may result in serious injury or
even death.
For adequate protection this helmet must fit or be adjusted
to the size of wearer’s head (see Adjusting the Suspension
Size below). The helmet is made to absorb the energy of a
blow by partial destruction to the shell or foam liner, and even
though such damage may not be readily apparent, any helmet
subjected to severe impact should be replaced. The attention
of users is also drawn to the danger of modifying or removing
any of the original component parts of the helmet other than
as recommended by the helmet manufacturer. Helmets
should not be adapted for the purpose of fitting attachments
in any way not recommended by the helmet manufacture.
Do not apply paints, solvents, adhesives, or self-adhesives
except in accordance with instructions from the helmet
manufacturer. Minimum operating temperatures as marked.
Provides electrical insulation as marked.
INSTRUCTIONS FOR USE
Adjusting the Suspension
Size:
The Cen10 helmet is equipped with
the FlexGen ratchet suspension. To
adjust the suspension, turn ratchet
knob counterclockwise until
headband opens to largest size.
Place helmet on your headand turn
ratchet clockwise until it fits comfortably snug.
DO NOT OVERTIGHTEN. See Figure 1
Replacement Recommendations:
Bullard recommends replacement every 12-18 months or more
frequently as needed for key replaceable parts such as the
comfort crown pad liner, ratchet cover, brow pads, and chin
strap.
Replacement Parts Instructions:
The comfort crown pad liner, ratchet cover, and brow are easily
removed as these are attached via Velcro. To remove and
replace the chin strap, unclip from the helmet and attach new
piece. See Figure 2
Cleaning, Replacing, and Storage:
Clean the helmet with mild soap and lukewarm water. Do not
use paint, solvents, chemicals, adhesives, gasoline, or like
substances on this helmet. The impact resistance and other
protective properties of the helmet may be diminished by such
substances. Damage caused by these substances may not be
apparent or readily detectable by the user.
Safety Helmet Use and Care Booklet
For Industrial Use
www.bullard.com
To Remove
To Lock
Figure 1
Figure 2
