Bull NovaScale 5 5 Series, User Manual, Page: 321 / 384

C-7
Error Messages and Recovery Information
SAL–A Hang POST Codes
POST Codes Meaning
0xDEAD0100 Unable to levelize local RAM
0xDEAD0200 Wrong chip under SNC (neither SPS, nor SIOH)
0xDEAD0300 PEL module not found, local firmware might be corrupted
0xDEAD0400 South Bridge Vendor ID is incorrect, expected ICH2 or ICH4
0xDEAD0500 Scalability Port 0 presence bit is not set
0xDEAD0600 Scalability Port 1 presence bit is not set
0xDEAD0700 Scalability Port 0 framing failed ( Idle Flits Ack. bit is not set )
0xDEAD0800 Scalability Port 1 framing failed ( Idle Flits Ack. bit is not set )
0xDEAD0900 Depending on the configuration:
– if configuration WITHOUT SPS: SIOH not accessible
– if configuration WITH SPS:
SPS 1 Vendor ID is incorrec
t
0xDEAD0A00 SPS 1 Vendor ID is incorrect
0xDEAD0B00 No SIOH could be found
0xDEAD0C00 Master IOB / IOC not found, at least one IOB / IOC should have logical
number 0
0xDEAD0D00 Mismatched SPS stepping, expected same stepping for both SPS chips
0xDEAD0E00 Non–transparent Bridge Vendor ID is incorrect, expected 21554 or 21555
0xDEADFF00 CVCR core–to–bus ratio is incorrect, expected 2:8, 2:9, or 2:10
0XDEAD3000 AUTOSCAN module not found, local firmware might be corrupted
0XDEAD3100 Unable to shadow AUTOSCAN module
0XDEAD3200 AUTOSCAN failed
0XDEAD3300 AUTOSCAN Memory Map has too many entries
Table 62. SAL–A hang POST codes (before release B600)
POST Codes Meaning
0xD000 Failure on SNC SP Checking
0xD001 No Framing on SNC SP0 (idle Flit Ack missing ...)
0xD002 No Framing on SNC SP1 (idle Flit Ack missing ...)
0xD003 No Framing on SNC SP0 and SP1 (idle Flit Ack missing ...)
0xD004 Master abort on SPINCO Read and chip is not a B–SPS
0xD005 Both Scalability ports disabled on SNC
0xD006 Unknown chip found behind SNC!
0xD100 Both Scalability Ports disabled on SNC
0xD101 Neither SIOH nor I–SPS or B–SPS found behind SNC
0xD102 No Firmware Hubs found on compatibility SIOH
0xD103 Autoscan returned an error on SPS based conf