Bull Escala PL 1650R-L+, Hardware Information

Page: 69 / 90

To place the system unit into the operating position, follow these steps:
Simultaneously release the blue rail safety latches, located near the middle of each rail, and push the
system unit into the rack. Both rack latches should lock into position.
Important: Ensure that the cables at the rear of the system unit do not catch or bind as you push the
unit back into the rack.
1.
Replace and tighten the two thumbscrews A that secure the system unit to the rack as shown in the
following figure. 2.
Close the front rack door. 3.
Parent topic: Remove the front cover from the model ESCALA PL 250R-L, PL 250R-L+ or PL 450R-VL+
Gain access to the model ESCALA PL 250R-L, PL 250R-L+ or PL
450R-VL+ control panels
Because only part of the model ESCALA PL 250R-L, PL 250R-L+ or PL 450R-VL+ control panels control
panel is visible from the front of the server, the following procedure describes how to gain access to all of the
control panel's features, including the display.
To access all of the control panel's features, complete the following steps:
Press inward on the spring-loaded tab A located on the right side of the control panel B so that it pops
out slightly, as shown in the following figure.
Figure 1. Gain access to the model ESCALA PL 250R-L, PL 250R-L+ or PL 450R-VL+ control panels
1.
Control panel
Gain access to the model ESCALA PL 250R-L, PL 250R-L+ or PL 450R-VL+ control panels 63