Bull Escala EL260B, Installation And User Manual

Page: 51 / 78

Chapter 3. Installing and removing options
35
3.9.1 Installing and closing the blade server cover
Install and close the cover of the blade server before you insert the blade server into the
Bull Blade Chassis. Do not attempt to override this important protection.
Figure 3-11. Installing the cover
Perform the following procedure to replace and close the blade server cover.
1. Read “Safety” on page ix and the Installation guidelines on page 19.
2. Lower the cover so that the slots at the rear slide down onto the pins at the rear of the
blade server. Before you close the cover, verify that all components are installed and
seated correctly and that you have not left loose tools or parts inside the blade server.
3. Pivot the cover to the closed position until it clicks into place.
4. Install the blade server into the Bull Blade Chassis. See Installing the blade server in a
Bull Blade Chassis on page 36.