Bull Escala EL260B, Installation And User Manual, Page: 32 / 78

16
Escala Blade EL260B - Installation and User's Guide
•
Use the management module to turn off the blade server.
The power-control LED can remain on solidly for up to 1 minute after you initiate the
power-off process. After you turn off the blade server, wait until the power-control LED
is blinking slowly before you initiate the power-on process from the advanced
management module to turn on the blade server again.
Use the management-module Web interface to configure the management module to
turn off the blade server if the system is not operating correctly.
For additional information, see the User’s Guide for the management module.
2.4 System-board layouts
The following illustrations show the connectors and LEDs on the system board.
The illustrations might differ slightly from your hardware.
2.4.1 System-board connectors
Blade server components attach to the connectors on the system board. The following figure
shows the connectors on the system board in the blade server.
Figure 2-2. System-board connectors