Bull 32X SCSI-2 CD-ROM Drive, Installation And Using Manual

Page: 15 / 41

Chapter 2. Preparing to Install the 32X SCSI-2 CD-ROM Drive
This chapter covers all the things you need to do before you install your 32X SCSI-2
CD-ROM Drive. Preparing to install the drive involves the following tasks:
v
Verifying your hardware requirements
v
Verifying your software requirements
v
Making sure your package is complete
v
Gathering tools and documentation
v
Planning your SCSI device layout
v
Determining your SCSI device address
Verifying Your Hardware Requirements
The 32X SCSI-2 CD-ROM Drive requires the following hardware:
v
An available bay large enough to hold a 5-1/4 inch half-high device
v
A SCSI-2 adapter, which is either built into or on a separate adapter card inside your
system unit
v
A SCSI interface cable
Verifying Your Software Requirements
The 32X SCSI-2 CD-ROM Drive is supported on several operating systems, including
AIX 3.2.5 or later. Ensure that your operating system supports this CD-ROM drive
before you install it. Contact your service representative for assistance.
Checking Your Package
Check that your package contains the following items:
v
The 32X SCSI-2 CD-ROM Drive
v
Mounting screws
v
A CD-ROM test disc
v
An 50 to 68 pin interposer
v
A registration card
v
7 jumpers (included on the jumper block)
Contact the place of purchase if an item is missing or damaged.
Note: Be sure to retain your proof of purchase, as it might be required to receive
warranty service.
Gathering Tools and Documentation
To install the drive, you need the following items:
v
Flat-blade screwdriver
v
Your system unit documentation
v
Your operating system documentation
3