Bull 296/C3, Manual, Page: 78 / 123

6
5
3
2
1
4
7
8
1 296/E3 5 Media Bay Chassis (Shown With
SCSI Media Drive Installed)
2 Operator Panel Power Cable 6 Media Bay Chassis Locking Tab (2)
3 Operator Panel 7 Front Bezel
4 Operator Panel Locking Tab (2) 8 Media Bay Chassis Guide Rail
Replacing the Operator Panel Power Cable
To replace the operator panel power cable, do the following:
1. Connect the operator panel power cable to the connector at the rear of the operator panel.
2. Carefully slide the operator panel into the operator panel bay until you feel the locking tabs lock in
place. If you are servicing the 296/E3, note how the operator panel power cable must be routed
through the system chassis before being connected to the media bay chassis.
3. Connect the the operator panel power cable to the media bay.
4. Replace the media bay chassis as described in “Replacing the Media Bay Chassis” on page 60.
5. Replace the front bezel as described in “Replacing the 296/C3 Front Bezel” on page 15 or “Replacing
the 296/E3 Front Bezel” on page 16.
6. Return the system to the operating position as described in “Returning the 296/C3 to the Operating
Position” on page 7 or “Placing the 296/E3 into the Service and Operating Position” on page 7.
7. Reconnect the system to the power source .
8. Start the system as described in “Starting the System” on page 8.
62
296/C3 and 296/E3 Parts Guide