Bull 296/C3, Manual, Page: 67 / 123

Disk Drive Bezels and Fillers
The following procedures describe the removal and replacement of disk drive bezels. Before performing
the following procedures, read the “Safety Notices” on page vii. Each disk drive slot in the system must
contain either a disk drive or the appropriate filler panel.
Removing a Disk Drive Bezel from a Disk Drive or Filler
To remove a disk drive bezel from a disk drive or filler, do the following:
1. Remove the filler panel from the disk drive slot, or follow the procedures for removing a disk drive
described in “Hot-Swap Disk Drives” on page 53.
2. Remove the disk drive bezel from the front of the filler panel or disk drive. See the following illustration.
3. Attach the disk drive bezel to the front edge of the filler panel or replacement disk drive.
4. Place the filler panel in the empty disk drive slot, or follow the procedures for adding a disk drive as
described in “Hot-Swap Disk Drives” on page 53.
1
2
3
4
4
5
1 Filler Panel, Upside Down with
Bezel Attached
4 Disk Drive Bezel
2 Disk Drive Bezel Handle 5 Disk Drive
3 Filler Panel Release Tab
Chapter 2. Removal, Replacement, and Installation Procedures
51