Bull Cedoc Bull Escala 2104 TS4, Installation Manual, Page: 12 / 87

Electrostatic discharge (ESD)
Attention: When you handle field-replaceable units (FRUs) and other computer
parts, take these precautions to avoid static damage:
v
Limit your movement. Movement can cause static electricity to build up around
you.
v Always touch the computer parts carefully. Hold the cards by their edges or metal
cover. Never touch any exposed circuits.
v
Prevent people who are not correctly grounded from touching computer parts.
v Before you install a new part, touch the static-protective package that contains
the part against an unpainted metal part of the 2104 Model TS4 or host system
for at least 2 seconds. This reduces the static electricity in the package and in
your body.
v
Remove the part from its package and, if possible, install it directly into the 2104
Model TS4 without putting the part down. If you must put the part down, follow
these steps:
1. Place the static-protective package that contained the part onto a smooth,
level surface.
2. Place the part onto the static-protective package. Do not place the part
directly onto any metal surface.
Safety inspection procedures
The safety inspection procedures describe how to inspect the 2104 Model TS4.
CAUTION:
The 2104 Model TS4 is designed to be installed by the customer and are
certified as customer setup. Make sure that the system or rack into which the
2104 Model TS4 will be installed is also designed and certified for customer
setup. If the 2104 Model TS4 are not, then they must be installed by a CE. (22)
x
2104 Model TS4 Installation Guide