Buhler SCS 104, Installation And Operation Instructions Manual

Page: 15 / 75

SCS 104
5.2.4 Description of menu functions
5.2.4.1 Main menu
Cooler of the SCS-system
Display →
ScS
This will take you to the cooler target temperature and the tolerance range setting (alarm
threshold).
Global setting (ToP Settings)
Display → toP
This menu is used to configure the global cooler settings.
Heat exchanger material selection
Display → h.chn
Heat exchanger material selection
Parameter range: tS (Steel), t6 (Glass), tU (PVDF)
Factory setting: tS (cooler without heat exchanger), or respective material per configuration
Exit main menu
Display →
E
Selecting this will return you to display mode.
5.2.4.2 Submenu 1
Target temperature (Temperature)
Display → Cooler →
temp
This setting determines the nominal temperature for the cooler temperature.
Parameter range: 2 °C to 20 °C (35.6 °F to 68 °F)
Factory setting: 5 °C (41 °F)
Note: If the temperature is changed the indicator may blink, until the new operating range has been
reached.
This menu item is hidden if the keylock is enabled.
upper alarm limit (alarm high)
Display → Cooler → A hi
Here you can set the upper threshold for the visual signal and the alarm relay. The alarm limit is set
based on the cooler temperature setting.
Parameter range: 1 °C to 7 °C (1.8 °F to 12.6 °F)
Factory setting: 3 °C (5.4 °F)
Note: This menu item is hidden if the keylock is enabled.
13 Bühler Technologies GmbH BECS0031 ◦ 02/2020