Bug-O Systems GO-FER III-OX, Instructions And Parts Manual

Page: 7 / 22

7
TORCH SET-UP
Insert the cutting torch into the torch holder
on the rack. Adjust the torch holder, the
clamp and the rack to set the torch to the
desired position. Support the supply cable in
the
Cable Anchor (J)
provided. The cable
anchor acts as a strain relief to keep the
supply cable from dragging the torch out
of position. Connect the contactor circuit
by crimping the two female connectors,
(supplied) to a 22-18 gauge, two-conductor
cable from the trigger circuit of the Plasma
unit and plug them into the leads on the plug
of the
Contactor Control Box (K).
MACHINE OPERATION
Set Switch (D)
to the center
“STOP”
position. Plug in the power cord. Verify the
Pilot Light (F)
comes on. Set
Switch (D)
to the forward or reverse position to begin
forward or reverse travel. Adjust the travel
speed using the
Speed Control (G)
.
The
Circuit Breaker (H)
protects the
unit against overload or electrical faults.
CAUTION: IF THE CIRCUIT BREAKER
OPENS, FIND AND CORRECT THE
CAUSE BEFORE RESETTING.
GO-FER III-PL / SETUP (Plasma)
M
N
B
C
H
M
F
J
G
D
A
K
N
L
TORCH SET-UP
Insert the cutting torch into the torch holder
on the rack. Adjust the torch holder, the
clamp and the rack to set the torch to
the desired position. Connect the
Hose
Assembly (J)
to the
Quick Action Manifold
(K)
and to the cutting torch. The manifold
acts as a strain relief for the supply hoses as
well as a quick shut off valve for the gases.
Once the torch valves are adjusted, the
manifold eliminates the need to readjust the
valves after each cut and keeps the supply
lines from dragging the torch out of position.
MACHINE OPERATION
Set Switch (D)
to the center
“STOP”
position. Plug in the power cord. Verify the
Pilot Light (F)
comes on. Set
Switch (D)
to the forward or reverse position to begin
forward or reverse travel. Adjust the travel
speed using the
Speed Control (G)
.
The
Circuit Breaker (H)
protects the
unit against overload or electrical faults.
CAUTION: IF THE CIRCUIT BREAKER
OPENS, FIND AND CORRECT THE
CAUSE BEFORE RESETTING.
GO-FER III-OX / SETUP (Oxy-fuel)
A
J
D
G
K
F
H
N
C
E
B
M
N
L
M
C