Buffalo TeraStation 5010 TS51210RH, User Manual, Page: 89 / 211

3
Enter the admin password. If you use SSH encryption during backup, enable SSH.
4
Click OK .
Backup Logs
The following backup error codes may be recorded in the backup log. Read the description and try the respective
corrective actions for each error.
Code Description Corrective Action Log Example
Code 3
The backup destination USB
drive could not be found.
Verify that the backup destination
USB drive is connected to the
TeraStation properly.
rsync error: errors
selecting input/
output files, dirs (code
3) at main.c(634)
[Receiver=3.1.0]
Can't write to backup
destination(target
disk is broken?).
Code 5
The backup destination shared
folder could not be found.
Verify that the Ethernet cable is
securely connected and that the hub
or other devices on the network are
turned on. rsync error: error
starting client-server
protocol (code 5) at
main.c(1504)
Authentication failed.
Try adding the rsync-compatible NAS
device from the server list again. @ERROR: auth failed
on module
A registered user does not
have permission to run. Verify the settings of the rsync-
compatible NAS device. @ERROR: permission
denied
Code 10
The Ethernet cable was
disconnected from the backup
source TeraStation when the
backup job started.
Reconnect the Ethernet cable.
rsync error: error in
socket IO (code 10)
at clientserver.c(128)
[sender=3.1.0pre1]
A backup destination doesn't
support the subfolders' access
restrictions. Select another backup destination
or remove the subfolders' access
restrictions.
88