Buffalo LinkStation 200B, User Manual

Page: 120 / 121

Information Code Description Corrective Action
I27 Checking the USB drive. -
I28
Formatting the USB drive.
Note:
Do not turn off the LinkStation’s
power.
-
I46
Data migration or conversion (RAID
migration) is in progress.
Note: Do not turn off the LinkStation’s
power.
-
I47
Data migration or conversion (RAID
migration) is in progress.
Note: Do not turn off the LinkStation’s
power.
-
I52 A new firmware version has been released.
Update the firmware by referring to the
“Updating the Firmware” section in chapter
8.
I54 The backup job failed.
Make sure that the backup job is
configured correctly. Make sure that the
NAS is on and not in standby mode. If
the backup job still fails, check the status
of the network and backup source and
destination.
Amber (Glowing)
When the power LED glows a steady amber, a new firmware version is available. Update the firmware to the newest
version.
Default Settings
Administrator’s Name admin
Password password
Shared Folders
“share”
*
and “info” for both Windows and Mac computers.
*The recycle bin is enabled by default.
IP Address
The LinkStation will get its IP address automatically from a DHCP server
on the network. If no DHCP server is available, then an IP address will be
assigned as follows:
IP address: 169.254.
xxx.xxx (“xxx” is assigned randomly when booting the
LinkStation.)
Subnet mask: 255.255.0.0
Registered Groups
“hdusers”, “admin”, and “guest” are default groups and cannot be edited or
deleted.
Microsoft Network Group Setting WORKGROUP
Ethernet Frame Size 1500 bytes
SMB2 Enabled
AFP Disabled
FTP Disabled
NTP Enabled
Print Server Disabled
119
Chapter 11 Appendix