WARNING:
!
If the supplied power cord or receptacle is damaged, it must be replaced by a BUFFALO Authorized
company technician, or a similarly qualified person in order to avoid a hazard.
It is recommended that this appliance be inspected by a qualified service technician for proper
performance and operation on a yearly basis.
Clean the outer shell of the machine with a damp cleaning cloth, wipe the surface of steel plate
or the outer surface of the machine lightly, when cleaning the shell, do not use corrosive cleaning fluid or
articles, do not use rigid cleaning appliances, so as not to scrape steel shell.
Cleaning, Care and Maintenance
The power supply must be disconnected before servicing, maintaining or cleaning this appliance.
The appliance is not jet stream approved. Do not clean the appliance with a water jet.
Never use the appliance as a step for cleaning or accessing the ventilation hood, Serious injury could
result from slips, trips or from contacting hot liquids.
8
Troubleshooting
The below charts are a guide to possible problems and causes. Please read through these and double
check any problems you may be having. The steps below will allow you to trouble shoot before placing a
service call.
•
Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has
been dropped or damaged in any manner. Contact your Buffalo dealer for repair.
•
Always unplug unit from power supply before servicing.
Fault
Probable cause
Action
Application
not working
The unit is not
switched on
Check the unit is plugged in correctly and switched on
Lamp has blown
Replace lamp (Lamp must have a light wave length of
253.7nm, please contact Buffalo)
Plug and lead are
damaged
A qualified technician should replace the power cord
Power supply
Check power supply or call a qualified technician to
replace the power cord
The door is not
shut correctly
Shut the door or call a qualified technician to replace
the switch
Transformer fault
A qualified technician should replace the transformer
Timer fault
A qualified technician should replace the timer
No power in but the
power light on
A qualified technician should replace the mainboard
No UVC
light inside
UVC light fault
A qualified technician should replace the light
Odour inside
Fan fault
A qualified technician should replace the fan
!
WARNING:
