6
Fitting the mounting bracket
SKR6.1R, SKR12.1R - Subject to technical modifications.
17
6.4
Installing mounting brackets on
roofs with monk/nun tiles
B
Depending on the distances determined (
Æ
page 14),
remove 2-3 roof tiles from a row in the area of the
rafters.
B
Position the mounting bracket:
– The mounting bracket must be installed in the
middle of the roof tile below.
– The mounting bracket must be installed directly
above the roof tile below it without touching this tile.
B
Mark the mounting bracket positions on the roof.
B
If required, use wooden spacer [3] supplied for height
compensation (pre-drill 9 mm).
B
Screw mounting bracket [1] with 3 screws 8 x 120 mm
[2] onto the rafter. Use a SW13 spanner.
B
Re-install the roof tiles.
Fig. 23 Mounting brackets on roofs with monk/nun tiles
1
Mounting bracket
2
Screws 8 x 120 mm
3
Wooden spacer 100 x 150 x 8 mm
NOTICE:
Roof leaks from fine, wind-driven
snow in the area of the mounting bracket.
B
If there is a larger gap between the top
and the bottom roof tiles, close this gap
using UV-resistant sealant.
6720646203-12.1ST
1
2
3
13
6
9
