Step Two
Assemble the seat by raising the front
platform and securing the center support
arm with the blue screw and one of the
washers. Be sure not to overtighten.
2
Step Four
Attach the receiver to your bicycle
seat post. There must be at least 1.75
inches of post exposed below the seat
to make this connection.
Keep this connection as high up the
seat post as possible. This will give the
rider more legroom when peddling.
4
1
Step One
Check all parts are included
Buddyrider®
Installation
Instructions
www.buddyrider.com
Step Six
Position the seat on the arm as far forward as
possible without interfering with your handle
bars or steering post.
Mark this position with a small pencil mark on
the bar behind the pet seat. Remove the pet
seat and then remove the metal support arm
from the bike using the quick release pin.
6
7
Step Seven
Position the pet seat as close to the
pencil mark as possible while lining up
the holes. Using the four red screws and
washers provided, mount the pet seat
to the metal bar. Make sure all four
screws are in position before tightening.
Be sure not to overtighten.
8
Step Eight
Install the assembled pet seat to the
bicycle using the quick release pin and
be sure to secure that with the cotter
pin provided or a small pad lock.
9
Step Nine
Once the harness is attached to the
Buddyrider, place your pet in the seat,
connect the two clips and adjust
as needed.
Step Five
Insert metal support arm, flat section up,
into the receiver. Secure with the quick
release pin as shown.
5
3
Step Three
Attach the harness as shown. Clips will
be in front and behind the neck, and
connected to the Buddyrider via the
straps on the sides.
Leave collar unclipped for now.
BUDDYRIDER TIP!
Before attempting to ride with your
little buddy, you may want to get them
comfortable in the seat first while it is
on the ground. Try treats to entice
them to sit in the Buddyrider if they
hesitate to get in.
Enjoy and have fun!
TIP!
ART-066-00-005-a