BÜCHI Labortechnik AG
Installation | 5
Operation Manual Interface I-300 Pro
31/102
5.1.2
Fitting interface unit on Vacuum Pump V-300
1
4
5
6
7
2
3
Fig. 9: Fitting interface unit on Vacuum Pump V-300
1
Interface unit
5
Casing front
2
Fixing screw for holder
6
Knurled-head screw
3
Metal plate
7
Holder
4
Rubber plug and threaded hole
Tools required:
Torx key Tx30
The Interface I-300 Pro can be mounted on the top of the Vacuum Pump V-300 using
a holder.
u
Remove the rubber plug (4) from the top panel of the vacuum pump. Use a screw-
driver if necessary.
ð
Underneath the rubber plug is a threaded hole for a screw.
u
Position the holder (7) over the threaded hole (4) and fix it in place using the screw
(2) supplied. When doing so, pass the screw through the hole in the metal plate
(3).
u
Feed the communication cable through the holder from the rear and connect it to
the COM port on the back of the interface unit.
u
Position the interface unit (1) on the holder and fix it in place using a knurled-head
screw (6) inserted from the back.
