Monobloc Audio
Digital Entrance Panel
Installer manual
15
3.3
SCS and logic addresses setup
The entrance panel manages SCS and logic addresses. It is possible to save up to 3999 addresses.
As a rule, the correspondence between the logic call addresses and the SCS addresses of the hand-
sets is saved in the device.
For example, logic address 1328 corresponds to SCS 1328.
Logic addresses may be changed, but they are always linked to the SCS setup address.
If the value entered is different from 0 or 1, an error message will be displayed (see the dedi-
cated section).
Press “
0
” to set logic type calls.
An audible signal confirms the
new setting.
Press “
1
” to set numeric type calls.
An audible signal confirms the
new setting.
3.3.1 Call type selection: SCS or logic
This operation can be used to setup the type of call to use.
The logic call (0) is set as a default.
