BTEK T419S, Service Manual

Page: 65 / 136

T419S Indicator Service Manual 65
7.2 ENQ & B-Cast commands
7.2 ENQ & B-Cast commands
A ACCUM command “If ACCUM APP is active this command will generate an accumulation transaction, but it does not
perform the print function”
P PRINT command “Performs same function as pressing the PRINT key. All Ports that are binded with PRINT type
will transmit the assigned print format”
S SELECT command Performs same function as pressing the SELECT key
T TARE command Performs same function as pressing the TARE key
U UNITS command Performs same function as pressing the UNITS key
Z ZERO command Performs same function as pressing the ZERO key
*F F1 command Performs same function as pressing the
F1
key
*I ID command Performs same function as pressing the ID key
*O OVER command Performs same function as pressing the OVER key
*N UNDER command Performs same function as pressing the UNDER key
*L TARGET command Performs same function as pressing the TARGET key
B SCALE command Changes the current scale to the next enabled scale
*G START command Performs same function as pressing the START key
*H STOP command Performs same function as pressing the STOP key
*J SAMPLE command Performs same function as pressing the SAMPLE key
*K SETUP command Performs same function as pressing the SETUP key
*1 F1 command Performs same function as pressing the F1 key
*2 F2 command Performs same function as pressing the F2 key
*3 F3 command Performs same function as pressing the F3 key
*4 F4 command Performs same function as pressing the F4 key
*5 F5 command Performs same function as pressing the F5 key
*Fires the event for the key.
Upper or lower case characters will perform the same function.
Only keys found on your model Z-series indicator front panel can respond as defined
above.