50 kW DC Fast Charger
INSTALLATION AND USER’S MANUAL
Page
4
of
26
This document is the
Property of BTCPower Inc.
and shall not be
copied, reproduced, or used as the basis for sale or manufacture
of apparatus without written permission.
29-May-19
Initial Release
1.
Safety Guidelines
SAVE THESE INSTRUCTIONS
This document contains important instructions for the installation, operation, and maintenance
of
50kW DC Fast Charger
. These instructions should be retained for future reference.
1.1.
Important Safety Instructions
WARNING
READ THIS MANUAL BEFORE YOU BEGIN
This
50kW DC Fast Charger
manages electricity and may be hazardous. The equipment should
be installed, adjusted, and serviced only by qualified electrical personnel familiar with the
construction and operation of this type of equipment and the hazards involved, and in full
compliance with all local and national codes and standards. Failure to observe this precaution
could result in severe injury or death.
Read this manual completely and become familiar with the equipment prior to performing any
procedures specified in the manual and energizing the equipment. Inspection and
maintenance of this equipment should be performed in accordance with the procedures
detailed in this manual.
In situations where it is not possible to perform an installation following the procedures specified
in this document, contact BTCPower, Inc. BTCPower, Inc. will not be responsible for any
damages that may occur resulting from custom installations that are not specified in this
document.
There are no user serviceable parts inside. For service, please contact customer service or your
local distributor.
DO NOT ATTEMPT TO REPAIR THE CHARGE STATION YOURSELF. SERVICE TO THE
UNIT SHALL ONLY BE PERFORMED BY A QUALIFIED PERSONNEL.
If your charging cable is somehow damaged, do not operate the charge station. Contact your
service representative for service immediately. Shut down the power to the charger by
switching the breaker on the supply panel to the off position.
SAFETY GUIDELINES
