12- 42
Service Manual
LWE130
© BT Europe AB
Electrical system – 5000
Parameters & adjustments
T-code
Valid from serial number
Date
Order number
675
914369-
2005-09-23
226057-040
From the hand terminal to the truck
To transfer a parameter set from the hand terminal to the truck use the
RESTOR PARAMETER function in the hand terminal:
•
Connect hand terminal. See “Connecting the hand terminal” on
page 27.
•
Select RESTOR PARAM from the menu and press ENTER.
•
Press ROLL to select the relevant memory slot (Mod 00 to Mod 31).
•
Press ENTER. The parameter set will be restored to the transistor
regulator’s memory.
12.10.6 Calibrating the speed potentiometer
General
The transistor regulator [A1] can be calibrated to allow the speed
potentiometer [R1] to give a smooth and symmetrical response over
the whole operating range. Perform a calibration in the following cir-
cumstances:
*
MAIN MENU
*
PARAMETER CHANGE
*
MAIN MENU
*
STEER TABLE
*
MAIN MENU
*
PROGRAM VACC
*
MAIN MENU
*
ALARMS
*
MAIN MENU
*
RESTOR PARAM.
ENTER
ROLL
SELECT Mod 00
SELECT Mod 01
SELECT Mod 02
SELECT Mod 31
OUT
SEM-X V
NO DATA FOR THIS
CHOPPER! (OUT)
ARE YOU SURE ?
YES = ENTER NO = OUT
STORING
Run all parameters
ENTER
ENTER
SEM-X
V..
24v
75A
00000
ENTER
ROLL
https://www.besttruckmanuals.com/
