Self Servicing
© BT Industries AB 180424-040
49
Jack setting position
•
Apply the jack to the jack point under the counter-weight.
CAUTION!
Be sure to use a jack whose capacity is 5.0 ton or more.
3.
Jack up to just prior to the wheels coming up off the ground
and loosen the hub nuts.
4.
Jack up until the wheels come off the ground.
Completely remove the air pressure from the tire then
remove the hub nuts and remove the wheel.
5.
To reinstall the wheel after changing a tire, perform the steps
for removing in reverse order.
The hub nuts should be tightened evenly and in the same
sequence as for the front wheels.
6.
After replacing the wheel, check and adjust the tire air pres-
sure.
Adding antifreeze
If the vehicle is left in an area where the temperature is less than
0°C, the cooling water will freeze and may damage the radiator
and/or cylinder block. In such cases, antifreeze coolant must be
used.
When long-life coolant (LLC) is used, it must be changed once
every two years.
Freezing temperature varies depending on the amount of anti-
freeze added.
Antifreeze mixture (%)
Freeze protection
temperature (°C)
-12
-15
-24
-35
Mixture (%)
25
30
40
50
1 Garage jack (unavailable in 1-ton models)
2 Pulsometric type jack
