Operation
6
CLS Pro 600 – Line and Contrast Sensor
49/108
►
Check this setting. Log on as
Admin
and call up the main menu
afterwards and then select the
\\configuration\remote control
ekr
sub-menu. The
enable remote control
function must be ac-
tivated.
6.3.1
Manual Mode
Setup and system configuration is carried out in this mode.
1. Use the up or down arrow keys ① to select the operating
mode
Manual
. The selected mode ② will be displayed with a
green border around it.
2. Press
ENTER
to confirm your selection.
The current mode will be displayed in the top right corner of the
screen ③. The sensor will switch over to the operating mode
Manual
.
6.3.2
Automatic
Automatic material web controlling is carried out in this mode, de-
pending on the scanning mode that was selected (edge or line).
1. Use the up or down arrow keys ① to select operating mode
Automatic
. The selected mode ② will be displayed with a
green border around it.
2. Press
ENTER
to confirm your selection.
3. The current mode will be displayed in the top right corner of
the screen ③. The sensor will switch over to the operating
mode
Automatic
.
6.3.3
Servo Center Position
The material web will always be kept in the servo-center position
in this mode.
1. Use the up or down arrow keys ① to select
servo center posi-
tion
. The selected mode ② will be displayed with a green bor-
der around it.
