© 2017 Brunner GmbH
Operating Instructions (1.14)
23
If after closing of the firing door the diagram with "Stage 1"
doesn’t appear, then there is a defect. Please control the
heater manually and inform the stove builder.
4
ADDING FUEL IN A WARM FIRE-
PLACE
According to the heat requirement, a new combustion can be started.
However, please not the basic rule that only after complete burning of the
previous load, a further load can be added. The wood burning concept re-
quires that load after load is burned, and not log after log.
When “END” is displayed in the combustion cycle graphic, there are still
some hot embers left from the last combustion cycle. The reloaded wood
will ignite from these hot embers only. For easy start, put some wood
chips directly on the the hot embers (slightly “spread” the embers, if nec-
essary). Close the stove door again.
From now on, EAS will control the combustion air supply. Closing the
door serves as a signal for the EAS, that the combustion process has
started. In the display, the combustion cycle graphic will show “Stage 1”
or “Stage 2”, depending on the combustion temperature.
