Bruker BMPC/2, Technical Manual

Page: 112 / 136

112 Z31823_00_05
Configuration (administrator)
This voice box system uses „Voice files“ for the speech output. This set of files is stored
in folders on the hard disk named „vocs“, „vocs1, and so on.
For future expansion of this system it may be necessary to have more than one set of
voice files, for example for other modems, languages etc. To allow for this expansion, it
is possible to set an index for the „vocs“ folder used. The default index is „0“ and means
that the software uses the voice files stored in the folder „vocs“. When the index is set to
„
1
“ the software will use the files stored in folder „vocs
1
“, and so on.
Once the modem and telephone number is entered you need to enter the following
parameters in the
Dialing Parameters / Dialing Rules
fields:
• Dial Mode: Tone (default) or Pulse
• Outside Line Code. This may be required if the BMPC/2 is connected to, for exam-
ple, a PABX telephone system.
• The international access code.
• The international country/region code where the unit is located.
• The city/area code where the unit is located.
To see what will be dialed for a given telephone number, simply enter this number in the
Test Dialing Parameters
field. The system shows you the number which would be dialed.
If you are entering a number in the preselected area code, then the system should only
show the local telephone number as shown in the above example.
12.3.4.2 E-mail Setup
The parameters for the e-mail settings can be supplied by the local system administra-
tor. In some cases it may not be necessary to use a user name and password, whereas
the fields will remain blank.
Figure 12.25Tools - Options - E-Mail Setup