Bruker BLAH500 E, Operating & Service Manual

Page: 11 / 52

Operating & Service Manual Version 002 BRUKER BIOSPIN 11 (51)
3
Installation 3
The installation of the device must be done only by an authorized and qualified
technician, in total accordance with the running standards.
BRUKER BIOSPIN assumes no liability for the customer’s failure to comply with
these requirements and is therefore not responsible or liable for any injury or
damage that occurs as a consequence of non-approved installation.
Initial Inspection 3.1
Mechanical Check 3.1.1
If damage of the shipping cardboard is evident, request the carrier's agent to be
present when the instrument is unpacked. Check the equipment for damage and
inspect the cabinet and panel surfaces for dents and scratches.
Claim for Damage 3.1.2
If the unit is mechanically damaged or fails to meet specifications upon receipt,
notify BRUKER or our representative immediately. Retain the shipping cardboard
and packing material for the carriers inspection as well as for subsequent use in
returning the unit if necessary.
Reshipment and Repackaging Requirements 3.1.3
Whenever possible, the original cardboard and packing material should be used
for reshipment. If the original packing material is not available, wrap the
instrument in heavy paper or plastic. Use a strong shipping container. If cardboard
is used, it should be at least 200 lbs. test material.
Use shock absorbing material around all sides of the instrument to provide a firm
cushion and to prevent movement from inside the container wall on each side.
Protect the front panel by means of cardboard spacers inserted between the front
panel and the shipping cardboard. Make sure that the instrument cannot move in
the container during shipping. Seal the cardboard box with a good grade of
shipping tape and mark the container :
"FRAGILE ELECTRONIC INSTRUMENT"