BRUEL & KJAER PULSE 7788, Technical Documentation Manual

Page: 38 / 62

PULSE Vehicle Pass ‐ by Test Systems – Installation Manual 32
Fig.6.2
Settings for the Ground
Station WLAN hardware
(base station)
9) As the signal broadcast power should not exceed the legally defined limits for the
region in which the system is operating, you must take into account the gain of the
antenna used and the output power setting.
Click the
Enable
checkbox next to
Frequency List
and then the
Edit
button to open
a list of broadcast frequencies to select from. Dependent on location, we
recommend the use of only frequencies between
5500 MHz
and
5700 MHz
.
Fig.6.3
Settings for the
communication frequencies
used
10) Go to the
Network
tab page to set the operational mode of the Base Station.
a) Set the
Network Mode
to
Bridge
.
b) Set the
Configuration Mode
to
Simple
.