6
l
© Brüel & Kjaer Vibro GmbH / 2 mm ds822 ATEX / 8.12.16 / technical specifications subject to change / C105507.001/V03
EN
2 mm displacement sensor system series ds822 ATEX
| Safety
Instruction
Assembly of the sensor:
1.8
Explosion protection
The measuring chain is suitable for use in potentially explosive environments. See chapter 5
“Explosion protection”on page 20 for details
i
N
OTE
!
The driver housings may not contact each other or any other conductive parts.
!
C
AUTION
!
The ceramic sensor tip is sensitive to shock. Transport and store the
displacement sensor only with the included protective rubber cap. Always keep
the protective rubber cap for later use.
To avoid damage, make sure, especially during assembly and while operating the
machine, that the sensor tip does not come into
contact with other objects.
Loose ceramic particles can lead to damage within the machine.
Check the tip of the sensor for damage before every assembly. Never install a
defective sensor.
i
N
OTE
!
Never pull the cable to open the connection. Doing so may damage the cable and
the connector ends.
