BRP ski-doo MACH Z 1000 SDI, Handbook

Page: 313 / 493

SECTION 06 - DRIVE SYSTEM
MMC2005-001_06A.FM
06-51
PULLEY DISTANCE AND ALIGNMENT 0
GENERAL
Both pulley distance and pulley alignment must be
checked out to ensure the highest efficiency of
the transmission system. Furthermore, optimum
drive belt operation and minimal wear will be ob-
tained only with proper pulley alignment.
CAUTION: Before checking pulley adjustment,
the rear suspension must be mounted on the ve-
hicle and track tension/alignment must be done.
Always check pulley adjustment after suspen-
sion is adjusted.
All Pulley Alignment Specifications Refer to:
X = Distance between straight bar and drive pulley
fixed half edge, measured between pulleys .
Y = Distance between straight bar and drive pul-
ley fixed half edge, measured at the end of
straight bar .
Z = Pulley distance is not adjustable on the REV
Series models.
GENERAL PROCEDURE
Remove guard, drive belt, driven pulley and air si-
lencer.
Loosen lock nut.
1. Lock nut
Untighten torque rod using a long hexagonal key.
1. Torque rod
2. Hexagonal key
Install driven pulley. By using driven pulley open-
ing tool (P/N 529 017 200) push the sliding half to
open the driven pulley.
DRIVEN PULLEY OPENING TOOL
Insert a straight bar 9.5 mm (.375 in) square, 48
cm (19 in) long or the proper alignment bar into the
opened driven pulley.

WARNING
Failure to correctly perform pulley alignment
may cause the vehicle to creep forward at idle.
1
A33D0FA
1
A33D0GA
2
529 017 200
A33D0HA