SET-UP
Charging Instructions for Sealed VRLA
Batteries with Voltage of 11.5 or Less
Batteries with voltage below 11.5 V may require
special equipment and procedures to recharge.
In charging an over discharged battery having a
terminal voltage of 11.5 V or lower, its internal
resistance may be too high to charge at a normal
charge voltage.
Therefore, it may be necessary to raise the voltage
of the battery initially (25 V as a maximum),
and charge for approximately 5 minutes. If the
ampmeter shows no change in current after 5
minutes, you need a new battery. Current flowing
into the battery at high voltage can become
excessive. Monitor amperage and adjust voltage
as necessary to keep current at the battery’s
standard amp rating. Charge for approximately 20
hours.
Rear View Mirrors Installation
Model(s): RXT and RXT-X
(International)
sbl2006-002-101_a
— Models
WITHOUT
the cluster bezel already
installed —
Remove and keep both screws [1] retaining
instrument cluster. Unplug and set cluster aside
for now.
sbl2006-002-101_b
NOTE:
At 2 places at bottom of cluster, rubber
shims [1] are folded on body for a tight fit; care
should be taken not to lose those shims so they
are reused when reinstalling cluster.
— Models
WITH
the cluster bezel already
installed —
CAUTION:
Cluster's locking tabs may break
when removing cluster bezel; extreme care
must be taken while performing bezel removing
procedure.
sbl2006-002-103_a
Take a small wooden stick (coffee stirrer type) and
chamfer its end; refer to photo.
8 / 29
2008-1
Predelivery
