SET-UP
Secure with an M6 x 30 hexagonal bolt [4]
(P/N 250 000 002) (with scotch grip — from
predelivery kit) and an M6 stainless steel flat
washer [3] (P/N 240 062 600) (from predelivery kit).
CAUTION:
Ensure to install flat washer
otherwise screw will damage grip end.
Torque bolt to 7 N•m (62 lbf•
in
).
Cover bolt by inserting rubber cap [5]
(P/N 277 000 203) (from predelivery kit).
Repeat steps for other side.
Handlebar Assembly
Model(s): International Only except X
1
2
Install cable support [1] on steering support [2]
and secure with:
– 3 M6 x 20 hexagonal bolts (P/N 207 162 060)
and
– 3 M6 flat washers (P/N 234 061 600) from
predelivery kit .
Apply Loctite
††
243 (blue – threadlocker) on bolt
threads.
Torque to 5 N•m (44 lbf•
in
).
Remove both wing nuts from threaded studs on
console.
Open front storage cover and remove storage tray
(if so equipped).
F02K0M6
Insert throttle cable and steering harness through
console hole and position steering assembly.
2
1
F02K0N6
Attach steering cable end [2] to steering stem arm
[1] and secure with the M6 x 30 hexagonal bolt
(P/N 211 000 061) from predelivery kit .
Apply Loctite 243 (blue – threadlocker) on bolt
threads.
Torque to 5 N•m (44 lbf•
in
).
NOTE:
Ensure threads protrude through elastic
nuts
†† Loctite is a registered trademark of Loctite Corp.
12 / 29
2008-1
Predelivery
