Subsection XX (COMMUNICATION TOOLS AND B.U.D.S.)
COMMUNICATION TOOLS AND
B.U.D.S.
SERVICE TOOLS
Description
Part Number
Page
MPI-2 DIAGNOSTIC CABLE..........................................................
710 000 851 ............................................. 3
MPI-2 INTERFACE CARD ..............................................................
529 036 018 ......................................... 3–4
SERVICE TOOLS – OTHER SUPPLIER
Description
Part Number
Page
MALE-FEMALE EXTENSION SERIAL CABLE...............................
............................................. 3
GENERAL
Refer to
PROCEDURES
for instructions on the
communication tools.
If communication problems occur, refer to
TROU-
BLESHOOTING
in this subsection.
TROUBLESHOOTING
DIAGNOSTIC TIPS
IMPORTANT:
Make sure all connections are
made and vehicle is powered up
before starting
B.U.D.S.
to allow proper communication between
the vehicle and B.U.D.S. software.
MPI-2 Connection Troubleshooting
MPI-2 Status Lights
The MPI-2 includes 2 status lights that indicate the
connection condition: USB and CAN.
Both lights
must be GREEN
for the MPI-2 to function prop-
erly. Otherwise, refer to the following charts.
vdd2006-001-151_b
Prerequisite for USB communication:
– PC Computer turned on
– MPI-2 connected to PC computer.
USB LIGHT
STATUS
WHAT TO DO
Light is
OFF
– Check USB connection between
MPI-2 and PC computer.
– Check USB operation on PC
computer (hardware or Windows
drivers).
Light is
GREEN
– Connections are GOOD.
Communication can take place
on USB side.
Prerequisite for CAN communication:
– MPI-2 connected to diagnostic connector on ve-
hicle.
– Tether cord installed on the vehicle engine cut-
off switch.
– ECM turned on (momentarily press the START
button).
– B.U.D.S. started and logged on.
CAN LIGHT
STATUS
WHAT TO DO
Light is
OFF
Check connection between MPI-2 and
diagnostic connector on vehicle.
Light is
RED
Check CAN wires/connectors on
vehicle.
Light is
GREEN
Connections are GOOD.
Communication can take place on
CAN side.
smr2014-026
1