BRP LYNX Radien 2019, Operator'S Manual

Page: 111 / 229

BASIC PROCEDURES
2. Apply and hold brake. Remain seated, refer to
RIDER POSITION
(REVERSE OPERATION) in RIDING THE VEHICLE for posture in-
formation.
3. With engine at idle speed, press and release the RER button.
4. Wait until reverse beeper sounds, then gently depress throttle
lever.
WARNING
Engaging the reverse mode is done by depressing the RER
button when the engine is running. Wait until the reverse
alarm sounds and the RER pilot lamp comes on in the digital
gauge before operating throttle to proceed in reverse. The
reverse speed is not limited. Always proceed with caution as
fast reverse could result in loss of vehicle stability. Come to
complete stop before depressing RER button. Always remain
seated and apply the brake before shifting. Ensure the path
behind is clear of obstacles or bystanders before proceeding.
Shifting in Forward
1. Bring vehicle to a complete stop.
2. Apply and hold brake.
3. Press and release the RER button.
4. RER pilot lamp will stop.
5. Apply throttle slowly and evenly. Allow drive pulley to engage
then accelerate carefully.
Shutting Off the Engine
Release throttle lever and wait until engine has returned to idle
speed.
Shut off the engine using either the emergency engine stop switch
or by pulling off the tether cord cap from the engine cut-off switch.
WARNING
Always remove the tether cord cap from engine cut-off switch
when vehicle is not in operation in order to prevent acciden-
tal engine starting or to avoid unauthorized use by children or
others or theft.
108
_________________