BRP Evinrude E-TEC, Manual

Page: 118 / 364

Electrical and Ignition
Flywheel and Stator Servicing
118
Stator Service
Disconnect stator harness connector.
Remove three allen head screws to remove stator.
To install stator, position stator on cylinder block.
Apply
Nut Lock to screw threads. Install screws
and tighten in crossing pattern to a torque of 84 to
106 in. lbs. (9.5 to 12 N·m).
Flywheel Installation
Install the outer edge of flywheel key parallel with
centerline of crankshaft.
Thoroughly clean the crankshaft and flywheel
tapers with
Cleaning Solvent and let dry.
Align the flywheel keyway and install flywheel.
Coat the threads of flywheel nut with
Triple-Guard
grease. Install the washer and nut and tighten to a
torque of 100 to 115 ft. lbs. (136 to 156 N·m).
Replace flywheel cover and recoil starter (rope
start models).
IMPORTANT:
Check ignition timing after fly-
wheel removal or replacement. Refer to Timing
Adjustments on p. 119.
1. Stator screws 006486

CAUTION
To avoid injury, keep hands and fingers clear
from the underside of the flywheel.
The magnets on the flywheel can cause the
flywheel to move unexpectedly and rapidly
toward the stator with great force.
1. Flywheel key 009754
1
1
002093
002090