BRP Evinrude E-TEC, Manual

Page: 105 / 364

105
Electrical and Ignition
Charging System Tests
6
Snap-On model MT540D are examples of testers
available.
Start and run the outboard at approximately 5000
RPM. Use the variable load tester to draw the bat-
tery down at a rate equivalent to the stator’s full
output.
•
The ammeter should indicate nearly full output,
approximately 25 A @ 5000 RPM.
Decrease the battery load toward 0 A.
•
Ammeter should show a reduced output. As the
current draw decreases, the battery voltage
should stabilize at approximately 14.5 V.
•
If results vary, check stator BEFORE replacing
the
EMM . Refer to Stator Tests on p. 103.
55 V Alternator Circuit
Check battery ground cable for continuity.
With the key switch ON, check battery voltage at
battery (12 V).
Then, use Electrical Test Probe Kit, P/N 342677,
and a digital multimeter set to read 55 VDC to
check voltage on white/red wires at J2 connector
of
EMM . Voltage at EMM connector should be 0.5
to 1 V less than battery.
With outboard running at 1000 RPM, voltage on
white/red wires should be 55 V. Voltage readings
at a specific speed (RPM) should be steady.
If there is any other reading, refer to Stator Tests
on p. 103. Inspect the stator wiring and connec-
tions. Inspect the capacitor wiring, connections,
and capacitor. Repair the wiring or replace a faulty
capacitor, stator, or
EMM .
Variable Load Test Diagram
1. Red wire (alternator output from EMM )
2. Starter solenoid
3. Battery cable terminal (B+)
4. Variable load tester
5. Ammeter
002077
Battery Charging Graph 002076
3
4
1
2
5
C
u
rrent (A) @ 13 VDC
Engine Speed (RPM)
1. J2 connector
2. Test probe
007261
1
2