BRP Evinrude E-TEC Series, Service Manual, Page: 61 / 342

59
ENGINE MANAGEMENT MODULE (EMM)
DIAGNOSTIC SOFTWARE FUNCTIONS
4
R
OPE
S
TART
M
ODELS
Diagnostic communications on non-running rope
start models requires that power is supplied to the
EMM .
Use Diagnostic Power Supply Tool, P/N 587005,
to supply power to the
EMM . The power supply
uses internal 9-volt batteries.
Connect Power Supply Tool to the engine harness
key/stop switch connector. Turn toggle switch to
the ON position to power the
EMM .
IMPORTANT:
Static tests require more power
than the internal batteries of the tool can provide.
Static tests performed using only the internal
power supply batteries will produce false results.
Use Accessory Power Cable Kit, P/N 5008092, to
connect an external 12 volt battery to the Power
Supply Tool
when performing these static tests:
•
Fuel pump
•
Fuel injector
•
Ignition coil
•
Oil injector
Static Information
Static information is viewed when the outboard is
NOT running. This includes manufacturing infor-
mation.
The outboard model and serial numbers displayed
on the
Identity screen must match the identifica-
tion label on the outboard swivel bracket.
The serial number and cylinder location displayed
on the
Injector Coefficients screen must match the
actual cylinder placement for each injector.
1. Engine harness key switch connector
2. Power supply tool
007385
Accessory power cables 007386
2 1
Identity Screen 008136
Injector Coefficients Screen 008137