BRP Evinrude E-TEC Series, Service Manual, Page: 34 / 342

32
ROUTINE SERVICE
LUBRICATION
LUBRICATION
Steering System
Grease the stainless steel output end of the steer-
ing cable with
Triple-Guard grease.
Use an appropriate cleaning solvent to remove
corrosion and dirt from output end of cable before
coating it with grease. Make sure wiper nut is
installed and not damaged.
Tiller Handle
Lubricate the tiller handle grease fittings with Tri-
ple-Guard grease.
Swivel Bracket and Trailering
Bracket
Lubricate the swivel bracket with Triple-Guard
grease.
Apply grease until the grease begins to flow from
the upper or lower swivel bracket areas.
Coat the pivot points of the trailering bracket with
Triple-Guard grease.
Tilt Tube
Lubricate the tilt tube grease fittings with Triple-
Guard grease.
WARNING
Failure to regrease as recommended
could result in steering system corrosion.
Corrosion can affect steering effort, mak-
ing operator control difficult.
1. Steering cable
2. Wiper nut
DR29546
1. Tiller handle fittings 007020A
1
2
1 1
1. Grease fitting
2. Tilt support
007032
1. Tilt tube fittings
2. Swivel bracket fittings
007033
2
1
1
2
1
2